Residential Roofing Contractors Gilbert: Repairing a Pitched Roof

Introduction

Either shingles or flashing has flaws, but how can you evaluate and replace them? The defected areas must be replaced as soon as possible. To replace the tar-type shingles, the residential roofing services in Gilbert, AZ recommend the below steps.

Steps to Repairing a Pitched Roof

• Locate the defect: Locating the source of the leak is a preliminary step so that further actions can be taken. First, start inspecting the leak in an unfinished ceiling. Also, have a look at the sheathing and rafters and look for the presence of any drip. Check the presence of the leak in an unfinished ceiling. Either the source of the defect will be in the corresponding location or the uphill from there. The drips coming from shingles from a singular point show the location of the source from a finished ceiling. Move along the rafters or structural members before you plan to stain the Sheetrock. Once you proceed up, have a look at the larger area.’

• Look at the suspected area: The flaws will likely be a damaged shingle or flashing. Have a look at the sheet metals connecting the pipes, chimneys, and the waterproof structure.

• Evaluate the complexity of the problem: There are many types of problems that need to be recognized; for example, is the shingle missing or ripped? Also, look whether the nailhead is misplaced. It can be found through eyes, as all nail heads look behind the shingles.

• Identify the presence of flashing problems: There are different types of flashing problems. Check if the flashing is away from the pipes or masonry. The flashing may be missing or corroded. The corrosion is the effect of the galvanic reactions of the nail.

• Wait for Suitable Weather Conditions: If there is any problem associated with the shingle, wait for a warm day. Neither let the roof gets too warm or cold, as both are not suitable for shingles. Always use a shingle ripper so that you can easily access to the damaged shingle. Grab on to nails and place them down at the designated positions. There are four nails per shingle. There are different varieties of shingles, including the three-tab types, heritage types, and t-locks.

• Remove the shingles: Nails holding the shingles (damaged), as well as the shingles, should be removed. Wipe the area after removing the flawed or broken bits. Now it is time to slide new shingles into a new place. Have a look at the tabbed end of the shingle. Check if the material has the tabbed end or has granulated material. Trim the shingle with a utility knife. Now put the hard surface upside down. Break and block access.

• Bend the shingles in the upper course: Use galvanized roofing nails to bend the overlapping shingles. Tap them gently through a new shingle in the above location. The nails must be uphill from the line. Well done! You have done it.

Residential roofing contractors in Gilbert provide the complete pitched roof installation and maintenance services. For more information, search Zona Roofing on a reliable search engine.